this paper describe the three dimensional finite element modeling and buckling analysis ofconventional pallet racking system with semi rigid connection. in this study threedimensional models of conventional pallet racking system were prepared using the finiteelement program ansys and finite element analysis carried out on conventional pallet rackswith the 18 types of column sections developed a...

Metal thin-walled members have been widely used in building industry. Usually they are utilized as purlins, girts or ceiling beams. Due to slenderness of thin-walled cross-sections these structural members are prone to stability problems (e.g. flexural buckling, lateral torsional buckling). If buckling is not constructionally prevented their resistance is limited by buckling strength. In practi...

In this paper, an analytical model is developed to determine the torsional-flexural buckling load of a channel column braced by unevenly distributed batten plates. Solutions of the critical buckling loads were derived for three boundary cases using the energy method in which the rotating angle between the adjacent battens was presented in the form of a piecewise cubic Hermite interpolation (PCH...

In this paper, tests on flexural buckling ( Lateral – Torsional ) of cold-formed steel(CFS) lipped Channel beams under restrained boundary conditions are described Two point loading for flexural tests have been established for 3.0m span to obtain uniform bending moment. The section sizes selected for testing are 100x50x10 mm, 100x50x15 mm and 100x50x20 mm with 1.6mm and 2.0mm thickness for the ...

Failure in cold-formed steel beams is generally initiated by one of three instabilities: local, distortional, or lateral-torsional buckling. For cold-formed steel joists, purlins, or girts, when the compression flange is not restrained by attachment to sheathing or paneling, distortional buckling may be the predominant failure mode. Experimental results on cold-formed steel beams with unrestrai...

in this paper, the finite element analysis of stability problem of vehicle composite drive shafts subjected to torsional loading is studied. first, using the minimum total potential energy principle, the governing equations are derived and then they are solved by finite element method. the initial geometrical imperfection which is usually in the form of radial displacement, is taken into consid...

Torsional dynamic analysis of carbon nanotubes under the effect of longitudinal magnetic field is carried out in the present study. Torque effect of an axial magnetic field on a carbon nanotube has been defined using Maxwell’s relation. Nonlocal governing equation and boundary conditions for carbon nanotubes are obtained by using Hamilton’s minimum energy principle. Eringen’s nonlocal stress gr...

When the out-of-plane stiffness of a beam is remarkably lower than the in-plane stiffness, the lateral-torsional buckling occurs. In this study, the behavior of mono-symmetric I-beams with discrete torsional and lateral bracings under the concentrated moment is investigated using the finite element analyses. Then, based on the numerical analyses, equation for the stiffness requirement is propos...

This paper presents an analytical method to calculate the buckling stress of a rectangular thin plate under nonuniform applied axial stresses. Two cases are considered, buckling of a plate simply supported on all four sides and buckling of a plate simply supported on three sides with one unloaded edge free and the opposite unloaded edge rotationally restrained. These two cases illustrate the in...

The bucking strength calculation includes the determination of global buckling strength, the effective plate width and the torsional buckling strength of open section stiffeners. In each calculation the classic strength formula should be modified considering the effect of initial imperfections and residual welding stresses. The calculation method of Det Norske Veritas design rules and the Euroc...